D-395 and RSP4iU

rancher333

Member
Joined
Aug 2, 2004
Messages
5
Reaction score
0
The board seems to be operating normally, but doesn't trigger a picture. Inside the camera I have a yellow wire to shutter, green to refresh, black to common and red to power on/off. I've tried several combinations of wires to the phone connector, but doesn't seem to make a difference. I haven't tried soldering to the board yet, maybe a last resort. With or without the camera connected, the board powers up, steady green for about 20 seconds, then goes into a walk test mode for about a minute then a steady red comes on for about 10 seconds. After that, the green blinks 3 or 4 times when it detects motion, nothing else happens. Any suggestions on wiring, etc? Thanks
 

Haymaker

Well-known member
Joined
Aug 6, 2002
Messages
2,586
Reaction score
5
rancher333,

Please be sure you wire the phone connector by shutter, refresh, power, and common position, and not by color. The color positions can and will vary between cables.
 
Top Bottom