Door shutting

chardy

Well-known member
Joined
Jul 19, 2003
Messages
139
Reaction score
0
Good morning.
I am using a D-360l for setup. I am having a problem with the camera shutting off because it does not take much for the door to slide and shut off camera. Almost everytime I put the camera in the box and shut the lid it shut down.

Any ideas that I could do to help from the camera slide from shutting?
I though about a on & off switch...
 

pocomoke

Well-known member
Joined
Jun 3, 2003
Messages
1,049
Reaction score
0
at the bottom of the door just below the lens opening is like a small slot.Cut a qtip body so that it fits nice and snug inside this slot and it will keep door from closing.Cut you a few extras and stick them inside the case because they get lost sometimes when checking cam...
 

bat

Well-known member
Joined
Jan 12, 2002
Messages
4,354
Reaction score
0
Masking tape, duct tape the door open or taper the foam a little on that side. You may have too much foam pressure behind the camera pushing it into the door foam as well. This make for a good flash seal but I prefer to use more foam in the door area and less behind the camera which will seal off the flash just as good. This way the camera will not stick out so that the door foam catches it as it is closing.
bat
 

jayber

Well-known member
Joined
Aug 20, 2002
Messages
2,010
Reaction score
0
I used electrical tape on my D360L model to keep the door open.
 

chardy

Well-known member
Joined
Jul 19, 2003
Messages
139
Reaction score
0
All good ideas.
Everybody on this site is very helpful.

Thanks for the information,,
 
Top Bottom