fixed and ready to go!

californiacoyotes

Well-known member
Joined
Oct 29, 2001
Messages
478
Reaction score
0
so i took my cam to work today to fix the wires that broke loose from the toggle. fixed those wires with no problem..but the cam didn't work. looked a bit closer and pulled the tape off where the wires connect to the camera and found that one of the wires had also been pulled loose there as well. i must of sat there for a half an hour think should i try on what. i tried to fix the connection to the curciut board but still couldn't get the camera to work. so there i sat again. i ended up taking it to maintaince and my buddy had it working in about twenty minutes! i have to say although i am not ready to take on making a cam myself it really doesn't look that difficult. probably the scaryest part is the camera connection. maybe in a couple months i'll give it a try.

cc
 



davered1

Well-known member
Joined
Sep 1, 2001
Messages
1,793
Reaction score
0
If you put some hot glue on top of the toggles when they are finished it protests points from touching anything and also gives it a little give if you pull on them a but(liquid rubber band)
 


Top Bottom