how do I crack this "Nut"

max

Well-known member
Joined
Dec 1, 2001
Messages
468
Reaction score
0
What is the best way to get into the socket to get at the chip set?
 



gizz

Well-known member
Joined
Mar 11, 2001
Messages
1,395
Reaction score
0
max - Any way you can!
Seriously, I used a strong set of Tin Snips and Pliers. Just tear little pieces at a time off until have it apart. Take your time as you'll need to clip a few wires as you go.
 

Gun Docc

Well-known member
Joined
Mar 11, 2001
Messages
640
Reaction score
0
heat and desolder the terminal ends from it then part it at the seam in the middle(you can do this with small wire snips) this is the best way i have found and it makes it easy to get the chipset out without damaging it

the only problem with this chipset is that i have found it useless unless you want problems bugging your setup...hehe

it is best to build a timer to use and no problems.

Later
 

spectr17

Administrator
Admin
Joined
Mar 11, 2001
Messages
69,674
Reaction score
503
Walnuts are easier to crack.

I remember when I bought my first Lamson and I just HAD to know where that telco cord went in the base. 1/2 hour later after some intense rasslin' and tin snippin I knew.
 


Top Bottom