I recieved 2 new universal boards from you,the one with the Lanc chip blinks red about ten times and stops for maybe 2 seconds,and goes through this sequence again and again.Is the chip faulty,I pulled the Rs232 chip out of the other board which works fine,and put Lance chip in that board.I get the same problem????Any help would be appreciated.
Sounds like the board is working just fine. The red blinking LED is a sign that it can't see the LANC signal. This can mean that the 2.5mm port is not configured or the cable isn't plugged into the board all the way. Please go to www.pixcontroller.com and read the information under the Universal board about configuring the 2.5mm port. Let me know if this solves your problem.