Joed timer

Basscat

Active member
Joined
Aug 18, 2001
Messages
36
Reaction score
0
I have joeds timer and im wanting to hook it up to the 5v output on the rs pir. Where is the output and where is the best place to hook in the - wire?
 

coyotebandit

Well-known member
Joined
Jan 23, 2002
Messages
1,892
Reaction score
0
Pin #1 of the RS pir supplies 5v, the best place to solder is on the bottom of the board. Don't let the chip heat up too much either..........or else.......:bounce-red-fire:

Pin # 2 is the signal from the PIR itself, again it's best to solder to the bottom of the board.
 

Basscat

Active member
Joined
Aug 18, 2001
Messages
36
Reaction score
0
Thanks for the info. Heres kinda a stipid question, but I promise ill only ask it once. Is negative current the same from say a 1.5v source and 12v source. I assume it is but is but Im not for sure.
 
Top Bottom