moisture inside frensel

buckman0

Member
Joined
Aug 9, 2001
Messages
9
Reaction score
0
set up cam for the first time , took pic of me and one doe . then the heat and rain started , the rest of the roll was taken of nothing . refilmed cam setup in different place , took pic of me leaving . then rain started again and the roll went in about 3 min. "cam time" . i get moisture inside the frensel lens when outside. now the cam will run the hole roll of film when the unit is turned on . question i have or did i answer it allready ,1] is the moisture causing the problem?
2] do i have something gone bad inside ?
3] also my led quit working .
4] has my relay inside the sesor gone south ?
the sensor i used is from radio shack
 



mike

Well-known member
Joined
Mar 23, 2001
Messages
54
Reaction score
0
I was going to say it might just be the moisture with the rain. But if your saying that your led isn't working anymore, I'd have to say take it apart and check all your connections. Just a reminder after you make your solder connections try using some shrink tube on them. Thats what I do on all the cameras and they seem pretty water proof. And maybe a small roof over your sensor. Hope this helps.
 


Top Bottom