Serial Cable Pinout for Olympus D-400Z Digital Camera
--------------------------------------------------------------------------------
This cable has a normal PC 9-pin D-sub female serial connector (DB-9) at one end and a standard 2.5 mm stereo audio stereo plug (male) at the other end. Only three signal wires are needed in the cable: ground (Gnd), transmit data (TxD) and receive data (RxD). Depending up what software you use, you also may need to "loop-back" data terminal ready (DTR) to data set ready (DSR) and request to send (RTS) to clear to send (CTS) on the DB-9 connector.
The stereo plug is wired to the PC serial port as shown in the following diagram:
DB9*: Optionally short together pin 4 (DTR) to pin 6 (DSR) and
pin 7 (RTS) to pin 8 (CTS)
The following table also describes the camera cable's wiring:
Camera PC's
Plug DB9* Signal Name Direction
---- ---- ----------- ---------
- 1 Carrier detect (CD) input to PC
tip 2 Receive data (RxD) input to PC
sleeve 3 Transmit data (TxD) output from PC
- 4 \ Data terminal ready (DTR) output from PC
ring 5 | Signal ground (Gnd) -
- 6 / Data set ready (DSR) input to PC
- 7 \ Request to send (RTS) output from PC
- 8 / Clear to send (CTS) input to PC
- 9 Ring indicator (RI) input to PC
* Note that the cable's D-subminature DB9 RS-232 serial port connector is female. This connector also goes by the historically more correct name of "DE-9J".
If you are using this cable with the "freeware" from "photopc", then you don't need to "loop-back" wires on pins 4/6 and pins 7/8 of the DB9 connector. However, these wires may be needed for the "official" Olympus Windows software.
Hint: The parts for this cable can be purchased at most any electronics parts store, such as Radio Shack. One option is to buy an audio "patch cable" with a 2.5 mm stereo plug molded onto one end, then cut off the other end and then wire it to pins 2, 3 and 5 of a DB-9 female connector. A quick continuity check with something like a digital volt meter (DVM) will tell you which wires go to which contacts on the stereo plug. All of the DB-9 connectors that I have come across have tiny pin numbers by the contacts to aid you.
Radio Shack sells a number of "flavors" of 2.5 mm stereo plugs, pre-wired patch cables and DB-9 connectors. It is even possible to avoid using a soldering iron for this by using a pre-wired patch cord and a DB-9 connector "kit" with "crimp-style" push-in pins.
To help make the "electrically inept" a bit braver about making their own camera cable, I wouldn't worry too much about possibly getting the wiring wrong at first and damaging something. PC serial ports use RS-232 signaling, which is electrically "robust" in that the inputs and outputs are protected against short circuits and unusual voltages. In my 30+ years of abusing RS232 serial port wiring, I have yet to damage a serial port. (However, you are on your own!)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
