Regent Power on Delay

Jaggermax

Inactive
Joined
Apr 6, 2001
Messages
505
Reaction score
0
Connected up the Mainstay PIR today (I guess it replaced the Regent but is the same board).  I removed the Relay and drive transistor since I am going to monitor the signal with a micro-controller and connected Pin 14 directly to one of my controler  I/O ports.  Everythings works fine, it is just that I do not care for the 30 second power up delay when the sensor is first turned on.  The output on pin 14 remains high and then drops to low after the initialization.  Do any of you know how to eliminate this delay?  (Guess I am impatient).  Thanks in advance guys!

(Edited by Jaggermax at 9:52 pm on April 21, 2001)
 


Top Bottom