where to wire

Rossco

Member
Joined
Aug 20, 2001
Messages
16
Reaction score
0
Hi all. I am working on my first camera and was wondering where on the owl pf is the best place for the two wires to be wired in?  Should they both be on the pins or can they be on the green part too?  Sorry this is my first camera and i was just wondering
Thanks for all the help.
 

Arrowhead

Well-known member
Joined
May 22, 2001
Messages
4,244
Reaction score
11
If by green part you mean the raw card, No you cannot solder anything to that. You'll have to solder to the pins. That's the only part where the trace isn't masked (covered).

Good Luck.
 

passgas55

Well-known member
Joined
Jul 25, 2001
Messages
270
Reaction score
0
I just finished my owl pf cam and the way I did it was to follow pins 5 & 6 to circuit board on top of shutter button to 2 round dots and use 1 wire to jump between those 2 dots and out the cam. Then I follow pin 4 to where it t's off,carefully scraped off the green coating soldered there and out the cam where I cut a hole by the shutter button.I jb weld the hole and pass the wires to the strap holder and jb weld that.Worked good for me.(just like in set up pictures)  
 

Advertisement



Top Bottom